BERETTA SHOTGUN PARTS-FIRING PIN C54731 / C54732

FIRING PIN

SCHEMATIC REFERENCE 12 gauge - A30048, A30466, A39066, A39166, AL39166, A391LIGHT66, A3000111

PART NUMBER – C54731

Beretta shotgun part 12 gauge FIRING PIN for A300, A304, A390, A391, AL391, A391LIGHT, A3000

FIRING PIN

SCHEMATIC REFERENCE 20 gauge - A30048, A39166, A391LIGHT66

PART NUMBER – C54732

Beretta shotgun part 20 gauge FIRING PIN for A300, A391, A391LIGHT

Cole Gunsmithing Service Work Order Request Form

   Note: It is recommended that all Beretta parts be installed by a qualified and trained gunsmith.

The firing pin in a Beretta shotgun is a thin, simple rod with a hardened, rounded tip that strikes and crushes the primer. When the trigger is pulled, the hammer released by the sear and pushed by its spring, rotates and hits the firing pin which then strikes the cartridge primer causing the firing.  Firing pins are a major component for proper performance and reliability.  Firing pins are good parts to carry in case of emergencies.

Below are some recommendations from Beretta for cleaning an over under shotgun:
Cleaning your Beretta over and under competition shotgun is important to keep it in good condition and ensure it functions properly. Here’s a guide on how to clean a Beretta over and under shotgun:

At the end of a hunting or shotting session, clean the shotgun and make sure the chokes are properly tightened. Metal surfaces on shotguns without protective surface treatment need to be cleaned thoroughly and lubricated after every use to protect against rust. Use a cotton cloth soaked in Beretta gun cleaner and a cleaning rod to remove firing residues from the barrels. Use a bronze brush if necessary. Always insert the cleaning rod into the cartridge chamber. Run a clean, dry cloth through the bores to remove detergent residues. Lightly oil the bores with Beretta gun oil on a clean cotton cloth. 

Never apply too much oil. A buildup of oil will attract dirt, and this can interfere with the shotgun’s operation and reliability. lean the inner face of the receiver (especially the area around the firing pin holes) and oil lightly. Do not allow oil to enter the firing pin holes. The hinge pin area is a very important coupling area. The receiver and fore-end iron are subject to very high loads and if not properly oiled, could cause seizing of parts or shotgun malfunctioning. Always make sure these parts are lubricated, following the instructions provided. Carefully clean the outer surfaces of the shotgun to remove all traces of dirt, sweat and fingerprints. Apply a thin layer of gun oil (good quality) to the shotgun, using a soft cloth.  WARNING… XCESS OIL OR GREASE CAN OBSTRUCT THE BORE, EVEN PARTIALLY; THIS MAKES FIRING VERY DANGEROUS AND CAN DAMAGE THE SHOTGUN AS WELL AS CAUSING SERIOUS INJURY TO THE SHOOTER AND BYSTANDERS.