BERETTA PART | 690-12 | COVER HINGE PIN SCREW


COVER HINGE PIN SCREW

SCHEMATIC REFERENCE – 12 – 69212, 69412

PART NUMBER – C5F279 - 692
PART NUMBER – C5J728 - 694

Beretta shotgun part COVER HINGE PIN SCREW for 692, and 694.

A cover hinge pin screw is a part that secures the cover hinge pin to the receiver. The cover hinge pin is a part that covers the hinge pin and protects it from dirt and damage. Beretta shotguns may have different types of cover hinge pins and screws depending on the model. This OEM factory original component is perfect as a spare on the workbench or as an immediate replacement piece on your Beretta over and under 692, or 694 sporting shotgun.

Gunsmithing for Beretta Shotguns NOTE: It is recommended that all BERETTA PARTS be installed by a QUALIFIED and trained gunsmith.

Cole Gunsmithing Service Work Order Request Form
Gunsmith installing a cover hinge pin screw
Below are some recommendations from Beretta for cleaning an over under shotgun: Cleaning your Beretta over and under competition shotgun is important to keep it in good condition and ensure it functions properly. Here’s a guide on how to clean a Beretta over and under shotgun: At the end of a hunting or shotting session, clean the shotgun and make sure the chokes are properly tightened. Metal surfaces on shotguns without protective surface treatment need to be cleaned thoroughly and lubricated after every use to protect against rust. Use a cotton cloth soaked in Beretta gun cleaner and a cleaning rod to remove firing residues from the barrels. Use a bronze brush if necessary. Always insert the cleaning rod into the cartridge chamber. Run a clean, dry cloth through the bores to remove detergent residues. Lightly oil the bores with Beretta gun oil on a clean cotton cloth. Never apply too much oil. A buildup of oil will attract dirt, and this can interfere with the shotgun’s operation and reliability. lean the inner face of the receiver (especially the area around the firing pin holes) and oil lightly. Do not allow oil to enter the firing pin holes. The hinge pin area is a very important coupling area. The receiver and fore-end iron are subject to very high loads and if not properly oiled, could cause seizing of parts or shotgun malfunctioning. Always make sure these parts are lubricated, following the instructions provided. Carefully clean the outer surfaces of the shotgun to remove all traces of dirt, sweat and fingerprints. Apply a thin layer of gun oil (good quality) to the shotgun, using a soft cloth. GREASE APPROPRIATE CONTACT POINTS.

WARNING… XCESS OIL OR GREASE CAN OBSTRUCT THE BORE, EVEN PARTIALLY; THIS MAKES FIRING VERY DANGEROUS AND CAN DAMAGE THE SHOTGUN AS WELL AS CAUSING SERIOUS INJURY TO THE SHOOTER AND BYSTANDERS. 

BUY YOUR SHOTGUNS FROM THE WORLDS LARGEST BERETTA PREMIUM SHOTGUN DEALER!

Buy shotguns and shotgun parts from the Worlds Largest Beretta Premium Shotgun Dealer!