BERETTA SHOTGUN PARTS-HAMMER RIGHT HAND 680 FIELD C51309, C53510, C5H183

HAMMER RIGHT

SCHEMATIC REFERENCE – 58 – S68058, 68058
PART NUMBER - C51309 20 gauge field
PART NUMBER - C35310 12 gauge field
PART NUMBER - C5H183 12 gauge sporting

BERETTA SHOTGUN part HAMMER RIGHT for 680

The hammer is a part of a firearm that is used to strike the percussion cap / primer, or a separate firing pin, to ignite the propellant and fire the projectile. It is so called due to the fact it resembles a hammer in both form and function. The hammer itself is a metal piece that forcefully rotates about a pivot point. When released, a linear hammer, under spring pressure, slides along the bore axis rather than pivoting around a pin placed perpendicular to the bore, as with the more common rotating hammer. The hammer then impacts the rear of the firing pin.

Note: It is recommended that all BERETTA PARTS be installed by a QUALIFIED and trained gunsmith.
Cole Gunsmithing Service Work Order Request Form CLICK HERE

Cleaning your Beretta over and under competition shotgun is important to keep it in good condition and ensure it functions properly.

Here’s a guide on how to clean a Beretta over and under shotgun:
At the end of a hunting or shotting session, clean the shotgun and make sure the chokes are properly tightened. Metal surfaces on shotguns without protective surface treatment need to be cleaned thoroughly and lubricated after every use to protect against rust. Use a cotton cloth soaked in Beretta gun cleaner and a cleaning rod to remove firing residues from the barrels. Use a bronze brush if necessary. Always insert the cleaning rod into the cartridge chamber. Run a clean, dry cloth through the bores to remove detergent residues.

Lightly oil the bores with Beretta gun oil on a clean cotton cloth.
Never apply too much oil. A buildup of oil will attract dirt, and this can interfere with the shotgun’s operation and reliability. lean the inner face of the receiver (especially the area around the firing pin holes) and oil lightly. Do not allow oil to enter the firing pin holes. The hinge pin area is a very important coupling area. The receiver and fore-end iron are subject to very high loads and if not properly oiled, could cause seizing of parts or shotgun malfunctioning. Always make sure these parts are lubricated, following the instructions provided. Carefully clean the outer surfaces of the shotgun to remove all traces of dirt, sweat and fingerprints. Apply a thin layer of gun oil (good quality) to the shotgun, using a soft cloth.

WARNING… XCESS OIL OR GREASE CAN OBSTRUCT THE BORE, EVEN PARTIALLY; THIS MAKES FIRING VERY DANGEROUS AND CAN DAMAGE THE SHOTGUN AS WELL AS CAUSING SERIOUS INJURY TO THE SHOOTER AND BYSTANDERS. 

COLE GUNSMITHING IS THE WORLDS LARGEST BERETTA PREMIUM SHOTGUN DEALER