BERETTA SHOTGUN PARTS-EJECTOR RAW RIGHT HAND LOWER 680 SERIES

BERETTA SHOTGUN PARTS-EJECTOR RAW RIGHT HAND LOWER 680 20 GAUGE

SCHEMATIC REFERENCE – 5 – S6805

PART NUMBER - C52329 - 12 GAUGE
PART NUMBER - C40346 - 20 GAUGE
PART NUMBER - C40630 - 28 GAUGE

Note: These parts are RAW, and must be fitted and heat treated.

Beretta shotgun part EJECTOR RAW RIGHT HAND LOWER for 680 SERIES

The ejectors are devices that are positioned on the sides of the barrel and eject the spent cartridges after firing and the breech is opened. The ejectors are very durable and consist of very few moving parts. The extractor is the component within a firearm that aids in the removal of the cartridge from the chamber. Like an ejector, it allows the shells to be removed from the chamber, without them being ejected out. Apart from a few blow-back operated designs, they exist in almost every modern firearm. In extractor shotguns the extractor does all the lifting of the shotgun shell. When the gun is opened, it uses the mechanical advantage of the barrels hinging open to raise the extractors and bring the shell just high enough for you to be able to remove it manually.

NOTE: It is recommended that all BERETTA PARTS be installed by a QUALIFIED and trained gunsmith.
Cole Gunsmithing Service Work Order Request Form

Below are some recommendations from Beretta for cleaning an over under shotgun:
Cleaning your Beretta over and under competition shotgun is important to keep it in good condition and ensure it functions properly. Here’s a guide on how to clean a Beretta over and under shotgun:
At the end of a hunting or shooting session, clean the shotgun and make sure the chokes are properly tightened. Metal surfaces on shotguns without protective surface treatment need to be cleaned thoroughly and lubricated after every use to protect against rust. Use a cotton cloth soaked in Beretta gun cleaner and a cleaning rod to remove firing residues from the barrels. Use a bronze brush if necessary. Always insert the cleaning rod into the cartridge chamber. Run a clean, dry cloth through the bores to remove detergent residues. Lightly oil the bores with Beretta gun oil on a clean cotton cloth.
Never apply too much oil. A buildup of oil will attract dirt, and this can interfere with the shotgun’s operation and reliability. lean the inner face of the receiver (especially the area around the firing pin holes) and oil lightly. Do not allow oil to enter the firing pin holes. The hinge pin area is a very important coupling area. The receiver and fore-end iron are subject to very high loads and if not properly oiled, could cause seizing of parts or shotgun malfunctioning. Always make sure these parts are lubricated, following the instructions provided. Carefully clean the outer surfaces of the shotgun to remove all traces of dirt, sweat and fingerprints. Apply a thin layer of gun oil (good quality) to the shotgun, using a soft cloth, and APPLY GREASE TO APPROPRIATE CONTACT POINTS

WARNING… EXCESSIVE OIL OR GREASE CAN OBSTRUCT THE BORE, EVEN PARTIALLY; THIS MAKES FIRING VERY DANGEROUS AND CAN DAMAGE THE SHOTGUN AS WELL AS CAUSING SERIOUS INJURY TO THE SHOOTER AND BYSTANDERS.
 BUY YOUR SHOTGUNS FROM THE WORLDS LARGEST BERETTA PREMIUM SHOTGUN DEALER!

 Buy shotguns and shotgun parts from the Worlds Largest Beretta Premium Shotgun Dealer!